GPM Racing Aluminium Side Steps (Reticulated Pattern A) - 10pcs Set for Traxxas 1/10 TRX4 (TRX4014XA)

Precision aluminium side steps for TRX4 platforms

These CNC-machined aluminium side steps are intended as scale accessories for TRAXXAS TRX4 trail crawler platforms and are catalogued under TRX4014XA. Components are produced with an anodised surface treatment and a post-anodise engraved reticulated pattern to produce visible contrast, with CNC profiling to ensure consistent dimensional tolerance and edge finish. The design focuses on appearance, secure modular mounting and repeatable alignment rather than structural load bearing.

The assembly uses adjustable screw-area plates that permit lateral offset adjustments so the steps can be located slightly inward or outward relative to the chassis rails. The kit contains the required stainless steel fasteners and allows for controlled visual and clearance tuning; these adjustments are not intended to affect suspension geometry.

Installation guidance: attach the left and right steps to the indicated mounting points using the supplied screws, adjust the screw plate position to set the desired offset, and apply appropriate torque to prevent thread damage while preserving the anodised finish.

Original Name / Part No:

Part location: Both sides of the car Is this part adjustable? YES The screw area is adjustable. Purpose: Allows the side step set inward or outward. This product includes: Side Step 2pcs, Stainless Steel Round Head Screws 3×10 8pcs.

Compatible Models

• TRAXXAS TRX-4 DEFENDER
• TACTICAL UNIT-82066-4
• BLAZER 82076-4

A technical scale upgrade that pairs CNC accuracy with anodised finish and adjustable mounting for refined side-step alignment on TRX4 crawlers.

What tolerances are targeted for fitment?

CNC cutting maintains consistent part geometry to help ensure repeatable fit; fine tuning is achieved via the adjustable screw plate to account for minor body or rail variances.

Is the engraved pattern applied before or after anodising?

The reticulated engraving is performed after anodising to expose contrast between the base aluminium and the anodised surface.

Can the screw plate be shimmed for extra offset?

Small shims or thin washers can be used during installation to increase offset if necessary, but ensure even seating and secure torque to avoid stress concentrations.

What maintenance preserves the anodised finish?

Clean with mild soap and water, avoid abrasive cleaners, and inspect fasteners for tightness to limit movement that could wear the anodised layer. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.