GPM Racing Aluminium Motor Mounts for Traxxas 1/10 MAXX (TXMS018N)

Precision motor mount for TRAXXAS MAXX applications

This aluminium motor mount is a CNC-friendly aftermarket replacement engineered to locate and stabilise the motor assembly on 1/10 scale TRAXXAS MAXX 4WD platforms. It features fixed mounting bosses and an adjustable stabilizer pin system to allow accurate motor placement relative to the spur gear for repeatable mesh and reliable drivetrain operation.

Installation follows standard motor-area procedures: remove the four fasteners on the motor base, install the stabilizing ring on the motor shaft, position the motor on the bottom mount and secure using the included hardware. The stabilizer pin can be relocated to alternate holes on the bottom mount to shift the motor fore or aft and precisely set pinion-to-spur clearance for improved gear life.

Packing includes

• Bottom mount – 1pcs
• Stabilize plate – 1pcs
• Stabilize ring – 1pcs
• Grade 12.9 black round head screw 4×12 – 2pcs
• Grade 12.9 black round head screw 4×8 – 1pcs
• Grade 12.9 black flat head screw 3×8 – 8pcs

Original Name / Part No:

8960

Compatible Models

• TRAXXAS-1/10 4WD MAXX MONSTER TRUCK -89076-4
• TRAXXAS-1/10 4WD MAXX W/WIDE MAXX MONSTER TRUCK-89086-4

Use this precision mount to hold the motor in a stable, repeatable position during mesh setup; adjust the stabilizer pin and torque the supplied hardware to maintain consistent engagement under load.

What components are included with the mount?

The kit contains the bottom mount, stabilize plate and ring, plus the Grade 12.9 fasteners listed in the Packing includes section above.

How is motor position adjusted for mesh?

Adjust motor position by choosing alternate stabilizer pin holes on the bottom mount. Move incrementally and verify mesh after each change to ensure correct contact pattern.

Can this mount handle high power setups?

The aluminium construction and Grade 12.9 fasteners offer robust mounting for typical high-power brushless setups; always verify gear alignment and inspect after heavy use.

Any recommended setup procedure?

Secure the motor lightly, fit the stabiliser ring, set a coarse mesh, then use the stabiliser pin to fine-tune. Tighten hardware evenly and recheck mesh after a short test run. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.