GPM Racing Aluminium Front Bumper with D-Rings - 15pcs Set for Axial 1/6 SCX6 Jeep JLU Wrangler 4x4 Rock Crawler RTR (SCX6330F)

Technical overview of the front bumper

This CNC-friendly aluminium front bumper is produced for the AXIAL SCX6 chassis and sized for the 1/6 4WD SCX6 JEEP JLU WRANGLER. Machined from 6061 T6 aluminium and finished with anodizing, the component balances corrosion resistance and low mass to suit scale crawling and trail operation. Part location: front bumper.

The assembly includes two D-rings, dedicated 5mm LED holders and stainless steel fasteners plus shims to ensure consistent mounting. Functionally the bumper provides a stiff contact surface to reduce transmitted impact loads to the chassis, while offering scale-correct mounting points for lighting and recovery hardware.

Assembly notes: use the supplied stainless screws to attach the bumper to the vehicle front. Verify hole alignment and thread engagement during installation, and apply the provided shims where indicated to achieve accurate seating and LED holder orientation.

Packing includes

• Bumper Base – 1pcs
• Bumper Top – 1pcs
• Bumper Secure Post – 2pcs
• SCX6330F D-Ring – 2pcs
• Stainless steel Cap Head Screws 2.5*12 – 2pcs
• Stainless steel Round Head Screw 2×4 – 2pcs
• Stainless steel Flat Head Screw 5×12 – 2pcs
• Stainless steel Shim 2*7*0.3 – 2pcs
• 5MM LED light – 1pcs

Original Name / Part No:

AXI250002

Compatible Models

• 1/6 4WD SCX6 JEEP JLU WRANGLER-AXI05000

Engineered for precision fit and enhanced front protection on AXIAL SCX6 builds, this anodized 6061 T6 bumper accepts 5mm LEDs and D-rings while maintaining required clearances to adjacent drivetrain components.

What tolerances should I expect during fitment?

The bumper is produced to tight machining tolerances; minor alignment adjustments using the supplied shims are normal to ensure a flush, repeatable fit.

Is the anodized finish serviceable after damage?

Small abrasions can be cleaned and left exposed or treated with compatible protective coatings, but full refinish requires anodizing processes not typically performed at home.

Can the LED holders accept other 5mm optical types?

The holders are sized for standard 5mm LEDs; verify lens profile and shaft diameter for tight tolerance fits and plan wiring routing to avoid contact with moving components.

Recommended fastener tightening practice?

Use a low-profile driver and torque carefully until components are snug; excessive torque can deform aluminium seating surfaces or strip threads in mating parts. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.