GPM Racing Alloy Hex Adaptor (+25mm)-4pcs Set for Traxxas 1/10 Slash 4x4 (SLA010/+25MM)

Precision hex adaptor for Slash 4×4 platforms

This 4-piece CNC-friendly alloy hex adaptor set is produced for fitment to the TRAXXAS 1/10 Slash 4×4 wheel hex and provides a +25mm outward offset per wheel. These components function as aftermarket tuning parts to alter track width and wheel placement for targeted handling and clearance adjustments.

Technical fit notes: verify hex pattern compatibility with the Slash 4×4 wheel interface, install one wheel at a time while monitoring clearance at full suspension travel, and re-torque wheel fastening hardware after a break-in run. Use appropriate torque values to avoid deformation of alloy seating faces.

Workshop tuning advice: employ the +25mm offset to evaluate changes in scrub radius and roll centre effects, inspect tyre and steering geometry after fitment, and sequence suspension and damper adjustments to achieve the intended handling balance.

How is the +25mm measured?

The +25mm refers to the lateral shift of the wheel mounting surface relative to the stock hex, measured per wheel; fitting all four increases total track width accordingly.

Recommended inspection routine?

After initial installation, verify torque and seating after a short run, then inspect adaptors and wheel hubs for wear or fretting at regular service intervals.

Are special tools required?

Standard wheel nut sockets and torque wrenches are sufficient; avoid impact tools for final seating to maintain accurate torque and prevent damage. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.