GPM Racing Alloy 6061-T6 Wheel 12mm Hex Adapters +3mm for Axial SCX10 III Jeep Wrangler Rubicon (SCX3010/+3M)

Precision wheel hex adapters for SCX10 III use

This aftermarket kit supplies CNC-style aluminium wheel hex adapters for Axial-compatible platforms to couple front CVD and rear drive shafts with scale wheels. The +3mm hub extension is intended to widen track and reduce wheel-to-hub clearance for improved side-load stability during technical driving.

The kit comprises 4pcs aluminium hex adapters and 4pcs stainless steel screw shafts M3.5x2x11.8, original part number AXI232018. Components are produced from 6061 T6 aluminium to balance reduced mass with tensile durability for RC-scale applications.

Assembly notes: these adapters replace the stock wheel hex interface and are retained by the supplied stainless shafts. Confirm spline alignment between wheel and drive spline, ensure screws achieve appropriate thread engagement, and verify wheel runout after mounting. Use correct hex driver sizes and perform torque verification after initial running to maintain secure fitment.

Compatible Models

• Axial AXI03007 SCX10 III Jeep Wrangler AXI03007
• Axial Capra 1.9 UTB -AXI03004

What spline checks are recommended?

Measure spline diameter and count on both the wheel and axle spline before fitting; ensure tight axial engagement and no lateral play prior to final torquing.

How should hardware be torqued?

Start screws by hand to avoid cross-threading, then tighten to firm engagement without over-torque; recheck after a short run to confirm no loosening.

Why 6061 T6 material?

6061 T6 provides a favourable strength-to-weight ratio for scale upgrades, offering adequate tensile properties while keeping rotating mass lower than heavier alloys. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.