GPM Racing 4140 Carbon Steel Front CVD Drive Shaft for Losi Team Losi 1/8 LMT 4WD Solid Axle Monster Truck (LMT076FS)

Front CVD drive shaft for LOSI LMT – technical overview

Aftermarket front CVD drive shaft engineered for the LOSI LMT 4WD solid axle monster truck platform. Manufactured from 4140 carbon steel and precision machined to interface with standard steel hex adapters, this shaft delivers drivetrain rotation to the front hubs while under load. It is intended for installation on the specified LOSI chassis only.

Service and fitment focus on the front CVD assembly where the shaft groove accepts the supplied 17*8 and 12*8 hex adapters. The kit includes both sizes of hex adapters and matching set screws; a single 17*8 adapter is supplied pre-installed on the shaft. Technically, routine inspection of set screw torque and mating surfaces is recommended after initial running and following heavy impacts to preserve retention and alignment.

Use this component to replace worn front CVD hardware or to reinstate front drive after impact damage. Its role is strictly mechanical torque transmission to the front wheels and it does not affect electronics, suspension geometry, or chassis structural layout.

Packing includes

• Front CVD – 2pcs
• 17*8 Hex adapter – 2pcs
• 12*8 Hex adapter – 2pcs
• Set screws 5×5 – 2pcs
• Set screws 4×3 – 2pcs

Original Name / Part No:

LOS242048,LOS242053

Compatible Models

• LOSI-1/8 LMT 4WD SOLID AXLE MONSTER TRUCK-LOS04022

This front CVD drive shaft is a direct-fit replacement for the LOSI LMT front CVD area, supplied with adapters and set screws sized to the shaft grooves, intended to restore front wheel drive and rotation on the identified LOSI 1/8 scale monster truck.

What tolerances are important when fitting this shaft?

Ensure the hex adapter seats fully on the shaft groove and that set screws align with the adapter flats; correct seating and secure torque prevent slop at the hub interface.

Can I reuse existing hex adapters from my truck?

Reusing adapters is possible if they match the 17*8 or 12*8 sizes and show no wear; replacement adapters are included for a reliable fit when required.

What inspections should be done after impact?

Check shaft straightness, adapter seating, and set screw engagement; replace any distorted adapters or damaged set screws to maintain correct drivetrain alignment.

Is heat treatment specified for this shaft?

The component is produced from 4140 carbon steel for strength in drive applications; follow routine inspection and replacement intervals based on use intensity to ensure serviceability. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.