GPM Racing Aluminium Front/Rear Brake Disk+Brake Caliper-8pcs Set for Traxxas 1/10 Ford GT 4-Tec 2.0 (GT006AB)

CNC machined brake disk and caliper assembly

This CNC machined aluminium disk and caliper set is engineered for the TRAXXAS 4WD GT4 TEC 2.0 brake disk area with an emphasis on precision fit and durability. Components are machined to consistent tolerances to replace the stock disk and caliper using the original mounting points.

The outer ring is increased to 8mm thickness and features a machined swirl pattern to control mass distribution at the rotor edge. The 8mm dimension versus typical 7mm stock increases effective track width when fitted on both axles, producing a predictable change to lateral stability during dynamic cornering.

Installation requires standard RC tools and common workshop practice: remove the wheel/hub, mount the disk, attach the caliper to the OEM mounts and secure all stainless fasteners to the recommended torque. After initial installation run a torque check and inspect for consistent rotor-to-pad alignment.

Specifications

• Item: Aluminium Front/Rear Brake Disk and Brake Caliper – 8pcs set
• Material: Aluminium, stainless steel fasteners
• Model Number: GT006AB
• Compatibility: TRAXXAS 4WD GT4 TEC 2.0
• Part Location: Brake disk area
• Included Parts: Brake Disk 2pcs, Brake Caliper 2pcs, Pin 2×10 2pcs, Stainless Steel Button Head Screw 2.5×5 2pcs

Recommended for hobbyists targeting a stiffer braking assembly and a controlled increase in track width; confirm hub compatibility and perform a post-install torque verification.

This item is compatible with

• TRAXXAS FORD GT4-TEC 2.0

What precision checks should I perform after fitting?

Check rotor runout and pad clearance, verify that the disk spins true without rubbing, and confirm all fasteners are tightened to spec before test runs.

Does the 8mm rotor require different pads?

Pad selection is dependent on compound and caliper geometry; the increased rotor thickness is primarily a dimensional change and usually works with standard pad types used on GT4 TEC 2.0 setups.

Are there longevity benefits to aluminium over stock parts?

CNC aluminium parts provide consistent dimensional stability and resistance to deformation, but long term wear depends on operating conditions, pad material and maintenance routines. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.