GPM Racing Spring Steel Completed Turnbuckles with Plastic Ball Ends - 7pcs Set (For Slash 4x4 / Telluride) for Traxxas 1/10 Slash 4x4 (SSLA160P)

Precision-engineered spring steel turnbuckles

This 7pcs completed turnbuckle set is intended for TRAXXAS Slash 4×4 platforms and Telluride models. Each assembly uses hardened spring steel rod sections with fitted plastic ball ends and is supplied ready for installation into existing linkage points.

Designed as direct-fit replacements where the ball end interface and length match, the assemblies provide corrosion-resistant spring steel shafts and low-friction plastic joints suitable for steering and rear toe adjustments. The components are aimed at hobbyists seeking reliable, repeatable linkage geometry during setup and tuning.

Supplied as a ready-to-install kit, the seven completed linkages remove the need to assemble rods and ball ends, speeding maintenance and replacement of bent or fatigued parts.

Compatible Models

• Slash 4×4
• Telluride

Use these completed turnbuckles to retain steering precision and consistent toe settings, noting they are intended specifically for Slash 4×4 and Telluride linkage configurations.

What is supplied in the SSLA160P kit?

Seven completed turnbuckles with spring steel rods and plastic ball ends, delivered ready to install into compatible linkage points.

Which chassis are verified compatible?

Compatibility is listed for Slash 4×4 and Telluride models in the compatibility box; confirm ball end type and overall length against your original parts.

How should I maintain these linkages?

Keep threaded areas clean and inspect plastic ball ends for wear; replace individual assemblies if the rod is bent or the joint shows excess play. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.