GPM Racing Alloy Hex Adaptor (+17mm)-4pcs Set for Traxxas 1/10 Slash 4x4 (SLA010/+17MM)

Professional alloy hex adaptor for Slash 4×4

This 4pc alloy hex adaptor set fits the TRAXXAS Slash 4×4 1/10 chassis and supplies a +17mm offset option to alter wheel position for tyre clearance and track width tuning. The design emphasises accurate fitment and repeatable offset for consistent setup changes.

Install by replacing the stock hex adaptors with these alloy units to move the wheel mounting point outward by +17mm, then validate tyre clearance and suspension articulation. The set includes four adaptors to service every wheel on a Slash 4×4, enabling balanced stance adjustments across the axle.

Workshop notes: perform standard wheel removal, apply correct wheel nut torque and inspect steering and suspension range of motion after fitment. Use initial test runs to confirm no drivetrain or steering interference and to fine tune alignment settings.

This item is compatible with

• TRAXXAS Slash 4X4

What measurements should I confirm before buying?

Verify your wheel hex diameter and hub interface match the Slash 4×4 standard. Confirm wheel backspacing and tyre profile to ensure the +17mm offset provides the clearance you need.

Are additional fasteners required?

Typically the adaptors use the existing wheel mounting hardware. Check the kit notes from your supplier and replace any worn wheel nuts or washers during installation for secure fitment.

How should I validate setup after fitment?

After fitting, re-torque wheel nuts, check for steering and suspension interference, and run a controlled test to inspect tyre clearance and drivetrain behaviour under load. Write Product Review Please sign in your account before you can write any review. Sign In Close

Made to order: GPM Racing parts are shipped to us from GPM’s factory, so please allow around 14 days for dispatch.